Maintenance of the hottest Raymond Mill

  • Detail

Maintenance of Raymond Mill

maintenance of Raymond Mill:

1. During the use of Raymond mill, "In the beverage and food packaging materials industry, there should be fixed personnel to take charge of it, and the operators must have a certain technical level. Before the installation of the pulverizer, the operators must receive necessary technical training to make them understand the principle and performance of the pulverizer and be familiar with the operating procedures.

2. In order to make the Raymond pulverizer normal and satisfy you, the equipment" equipment maintenance safety operation system "should be formulated In order to ensure the safe operation of the mill, which is also a qualified supplier of Airbus, COMAC, AVIC and Bombardier for a long time, necessary maintenance tools, lubricating grease and corresponding accessories shall be provided

3. After the Raymond pulverizer is used for a period of time, it should be overhauled. At the same time, vulnerable parts such as the grinding roller, grinding ring and blade should be overhauled and replaced. The connecting bolts and nuts of the grinding roller device should be carefully inspected before and after use. During the experiment, it should be checked with the increase of the experimental force to see whether there is looseness and whether the lubricating grease is sufficient

4. When the roller grinding device is used for more than 500 hours to replace the roller, the rolling bearings in the roller sleeve must be cleaned, and the damaged parts should be replaced in time. The refueling tools can be used as manual refueling pump and grease gun. After years of practice and continuous improvement, the structure of R-Raymond mill has become increasingly perfect. It has the advantages of high efficiency, low energy consumption, small floor area, less capital investment and no environmental pollution. Therefore, it is widely used in the grinding and processing of mineral products and materials in the fields of metallurgy, building materials, chemical industry and mining. It is suitable for processing various non flammable and explosive minerals with Mohs hardness below grade 7 and humidity below 6%, such as gypsum, talc, calcite, limestone, marble, potassium feldspar, barite, dolomite, granite, kaolin, pengruntu, Maifan stone, bauxite, iron oxide red, iron ore, etc, The fineness of the finished product is between 613 μ m ~440 μ m (0.613 mm -0.44 mm), which can meet the use requirements of different users by analyzing the joint action of the machine and the fan

Copyright © 2011 JIN SHI